With Disc Brakes

WHEEL HUB, HUB SPINDLE REMOVAL/INSTALLATION (DISC BRAKE MODEL)

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.





1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.

ABS Sensor Rotor Removal Note

NOTE: The sensor rotor does not need to be removed unless replacing it.





- Remove the sensor rotor by using a chisel.

ABS Sensor Rotor Installation Note
1. Install a new rear ABS sensor rotor onto the wheel hub.

NOTE: The ABS sensor rotor can be installed in either direction.





2. Using a steel plate and the SST, press the rotor on until it is flush with the wheel hub.