Key Replacement or Addition

Key Replacement or Addition




When customer has brought two or more valid keys

NOTE: If no specific time interval is given, step should be performed within 30 seconds of the previous step.

1. Cut new transponder equipped key(s).
2. Using key 1, turn ignition switch to ON then back to LOCK five times. Key should not remain ON or LOCK for more than one second.
1. Turn key 1 back to ON. Observe illumination of security light in instrument panel.
2. Turn key 1 to LOCK and remove key 1 from steering lock. Observe security light goes out.
3. Using key 2, start engine. Observe security light illumination (for 1-2 seconds) and engine continues to run.
1. Turn key 2 to LOCK and remove from steering lock.
4. Repeat step 3 with key 1.
5. Repeat step 3 with key 3.
6. If there are 4-8 keys (valid and/or new keys), repeat step 3.
7. Wait for 30 seconds to quit reprogram mode.




When customer has brought only one or no valid key (code word is required)

NOTE: If no specific time interval is given, step should be performed within 30 seconds of the previous step.

1. Cut new transponder equipped key(s).
2. Using key 1, turn ignition switch to ON then back to LOCK five times. Key should not remain ON or LOCK for more than one second.
1. Turn key 1 back to ON. Observe flashing of security light (300 ms ON - 300 ms OFF) in instrument panel.
2. Turn key 1 to LOCK and wait for 5 minutes until security light decrease in flashing frequency to 1.2 seconds.
3. Input code word.
4. Observe security light stops flashing and illuminates.
5. Start engine by key 1. Observe security light illumination (about 1-2 seconds) and engine continues to run.
6. Turn key 1 to LOCK and remove from steering lock.
3. Using key 2, start engine. Observe security light illumination (for 1-2 seconds) and engine continues to run.
1. Turn key 2 to LOCK and remove from steering lock.
4. Repeat step 3 with key 3.
5. If there are 4-8 keys (valid and/or new keys), repeat step 3.
6. Wait for 30 seconds to quit reprogram mode.