Rear Door: Service and Repair

1. Disconnect the negative battery cable.
2. To remove the checker, remove the rear door screen.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.




5. Adjust the rear door gap and height.

Connector Removal Note
1. Remove the rubber boot from the connector.
2. Pull out the green pin out until it stops.
3. Disconnect the connector.

Connector Installation Note
1. Push the green pin until it stops.
2. Install the rubber boot to the connector.
3. Connect the connector.
4. Repush the green pin until it stops for locking the connector.