Scan Tool Testing and Procedures

NOTE: In this mode, it is possible to check as following chart.




Diagnostic Trouble Code Chart

Operating Order
1. Turn the ignition switch to LOCK.
2. Disconnect the negative battery cable.
3. Reconnect the negative battery cable after 30 seconds or more.
4. Cycle the ignition switch to ON to LOCK 3 times.
5. Turn the ignition switch to ON.
6. Push the odometer/tripmeter switch 3 times.

Checking Order

NOTE
^ The diagnostic trouble codes are displayed in numerical order. (While performing the inspection, if you want to inspect a diagnostic trouble code of which the number is smaller that the code number you are currently inspecting, terminate the check mode then repeat the inspection from the beginning)
^ The diagnostic trouble codes can be fast forward by pushing and holding the odometer/tripmeter switch 1 second or more.
^ If rotate the wheels in the codes other than the DTC 10, cancel the input/output check mode.

1. Push the odometer/tripmeter switch and select the diagnostic trouble code.
2. Inspect each diagnostic trouble code by following the related inspection procedures.

Cancel Order
^ Cancel the input/output check mode by turning the ignition switch to LOCK then back to ON.

NOTE: Cancel the input/output check mode by leaving the instrument cluster in check mode for approximately 45 minutes.