Operation CHARM: Car repair manuals for everyone.

Brake Fluid: Service and Repair

BRAKE FLUID INSPECTION





1. Depress the brake pedal several times, and inspect for leakage of the brake line system.
2. Verify that the fluid level in the reservoir is between the MAX and MIN lines on the reservoir.
3. If the fluid level is extremely low, inspect the brake system for leakage.

Fluid specification: SAE J1703 or FMVSS166 DOT - 3

BRAKE FLUID REPLACEMENT

CAUTION: Brake fluid will damage painted surfaces. If brake fluid does get on a painted surface' wipe it off immediately.

1. Remove the brake fluid from the reservoir by using a suction pump.
2. Fill the reservoir with clean brake fluid.
3. Attach a vinyl tube to the farthest bleeder screw and place the other end of the tube in a clear container.





4. Remove all old brake fluid from the brake lines by loosening the bleeder screw and pumping the brake pedal until only clean fluid is seen. The reservoir should be kept about 3/4 full during bleeding to prevent air from reentering the lines.
5. Perform the above for all bleeder screws.
6. Fill the reservoir to the specified levels.