Drive Axles, Bearings and Joints: Service Precautions

PRECAUTION (DRIVELINE / AXLE)
Wheel and Tire Removal/installation
- The removal and installation procedure for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 89 - 117 Nm 19.0 - 12.0 kgf-m, 66 - 86 ft. lbs.).

Brake Line Disconnection/Connection

CAUTION: Brake fluid will damage painted surfaces. If brake fluid does get on a painted surface, wipe it off immediately.

- Tighten the brake pipe flare nut by using the SST (49 0259 770B). Be sure to modify the brake pipe flare nut tightening torque to allow for use of a torque wrench-SST combination.
- If any brake line has been disconnected any time during the procedure, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.

Suspension Arm Removal/Installation
- Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.

NOTE: Unloaded ... Fuel tank full; engine coolant and engine oil at specified level; spare tire, jack, and tools in designated position.