Front

DISC PAD THICKNESS INSPECTION
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove the wheels.
3. Verify the remaining thickness of the pads.

Thickness: 2.0 mm (0.008 inch) minimum.





4. Replace the pads as a set: right and left wheels, if either one is at or less than the minimum thickness

DISC PLATE THICKNESS INSPECTION
1. Measure the thickness of the disc plate.

CAUTION: When it is necessary, to machine the disc plate, and the disc plate is removed from the vehicle then machined, excessive runout may result. Machine the disc plate which is installed on the vehicle.

Minimum 22 mm (0.87 inch)
Minimum thickness after machining by using a brake lathe on-vehicle: 22.8 mm (0.90 inch)

2. If the thickness is not within the specification, replace the disc plate.

DISC PLATE RUNOUT INSPECTION
1. Verify that there is no looseness in wheel bearing.
2. Measure the runout at the outer edge of the contact surface of the disc pad.

Runout: 0.05 mm (0.002 inch) maximum.





3. If the runout is not within the specification, repair or replace the disc plate.