Cooling System Inspection

ENGINE COOLANT LEVEL INSPECTION








1. Remove the radiator cap (FS) or coolant filler cap (KL).
2. Verify that the coolant level is near the bottom line of the radiator filler neck (FS) or coolant filler neck (KL).
3. Verify that the coolant level on the coolant reservoir is between the F and L marks.
4. Add coolant as necessary.

ENGINE COOLANT LEAKAGE INSPECTION
1. Inspect the coolant level.
2. Remove the radiator cap.





3. Connect a radiator cap tester and the SST to the radiator filler neck (FS) or reservoir filler neck (KL).

CAUTION: Applying more than 123 kPa {1.25 kgf/cm2, 17.8 psi} can damage the hoses, fittings, and other components, and cause leaks.

4. Apply pressure to the radiator.

Pressure: 123 kPa {1.25 kgf/cm2, 17.8 psi}

5. Verify that the pressure is held. If not, inspect the system for coolant leakage.