Steering Shaft: Service and Repair

DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of removal.

Steering Lock Mounting Bolts And Bracket Disassembly Note (1)





1. Make a groove in the heads of the steering lock mounting bolts by using a chisel and a hammer.
2. Remove the bolts by using a screwdriver.
3. Disassemble the steering lock component.

Steering Lock Mounting Bolts And Bracket Assembly Note (1)





1. Assemble the steering lock component.
2. Put the key into the steering lock component and verify that the lock operates correctly.
3. Install new-steering lock mounting bolts.
4. Tighten the bolts until the heads break off.

STEERING SHAFT INSPECTION
Inspect for the following and replace the steering shaft component as necessary.
1. Column bearing rotates smoothly and there is no damage.





2. Steering shaft length is within the specification.

Length: 516.4 mm (20.33 inch).





3. Tilt operation
a. Verify that the adjusting lever moves smoothly from unlock position to lock position.
b. Verify that the steering shaft is fixed firmly when the adjusting lever is locked.

STEERING LOCK (ATX MODEL) INSPECTION





- Verify that the cable connector does not move when the key is in the LOCK position and that it moves freely with the key in other positions.