Non-Trouble Code Diagnostic Procedures - ABS

1. Select ABS-ANTILOCK BRAKE SYSTEM in the same procedure as the reading DTCs procedure.





2. Move the cursor to PID/DATA MONITOR AND RECORD. Press the trigger key to enter this selection.
3. Move the cursor to PID values to view. Press the trigger key.
4. Press START.

CONTROLLING MOTOR RELAY AND SOLENOID VALVES
1. Select ABS-ANTILOCK BRAKE SYSTEM in the same procedure as the reading DTCs procedure.





2. Move the cursor to ACTIVE COMMAND MODES. Press trigger key to enter this selection.





3. Press the trigger key to enter ABS OUTPUT CONTROL.





4. Move the cursor to EVAC FL: OFF. Press the trigger key to make EVAC ON.
5. Move the cursor to appropriate item and press the trigger key to make it ON.

CONTROLLING INDICATOR LIGHTS
1. Select ACTIVE COMMAND MODES in the same procedure as the "Controlling motor relay and solenoid valves". Press the trigger key.





2. Move the cursor to INDICATOR LAMP CONTROL II and press the trigger key.
3. Move the cursor to appropriate item and press the trigger key to make it ON.

CONTROLLING ENGINE TORQUE
1. Select ACTIVE COMMAND MODES in the same procedure as the "Controlling motor relay and solenoid valves". Press the trigger key.





2. Move cursor to DESIRED ENGINE TORQUE and press the trigger key.
3. ENG TOR will be indicated. Press the trigger key.
4. Control the engine torque to the desired value by turning the dial.