Drum Brake Model

WHEEL HUB, HUB SPINDLE REMOVAL/INSTALLATION (DRUM BRAKE MODEL)
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.

Locknut Removal Note





1. Raise the staked portion of the locknut by using a small cape chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.

ABS Sensor Rotor (With ABS) Removal Note

NOTE: The sensor rotor does not need to be removed unless replacing it.





- Remove the sensor rotor by using a chisel.

ABS Sensor Rotor (With ABS) Installation Note

NOTE: The ABS sensor rotor can be installed in either direction.

1. Install a new rear ABS sensor rotor onto the wheel hub.





2. Using a steel plate and the SST, press the rotor until it is flush with the wheel hub.





Locknut Installation Note
- Install a new locknut and stake it as shown.

Tightening torque 177 - 235 Nm (18.0 - 24.0 kgf-m, 131 - 173 ft. lbs)