Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE SWITCH ADJUSTMENT [GF4A-EL]
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct, and air cleaner component.
3. Remove the spring pin and clip and disconnect the selector cable.
4. Rotate the manual shaft to N position.
5. Disconnect the transaxle range switch connector.
6. Loosen the transaxle range switch mounting bolts.





7. Connect an ohmmeter between terminals A and H.





8. Adjust the switch to the point where there is continuity between the terminals.
9. Tighten the transaxle range switch mounting bolts.
10. Verify that the selector lever range position and transaxle range switch are aligned.
11. Connect the transaxle range switch connector.
12. Connect the selector cable and install a new spring pin and clip.
13. Install the air cleaner component, fresh-air duct, and resonance chamber.
14. Connect the negative battery cable.