Fuel Tank: Testing and Inspection

1. After setting up the NGS tester for current vehicle, select "DIAGNOSTIC DATA LINK" and press the TRIGGER.




2. Select, "PCM-POWERTRAIN CONTROL MODULE" and press the TRIGGER.




3. Select "PID/DATA MONITOR AND RECORD" and press the TRIGGER.




4. Press Number 5 under CLEAR to clear previously selected PID's.

NOTE:
- PID screen will very with different model's.




5. Turn the menu dial clockwise or counter clockwise to highlight CDCV and select by pressing the TRIGGER.




6. Turn the menu dial clockwise or counter clockwise to highlight FTP and select by pressing the TRIGGER.




7. PUSH Number 7 under START to view PID's.




8. When you begin the drive mode PRESS TRIGGER to capture the data refer to the DRIVE MODE PROCEDURE.

NOTE:
- Watch the CDCV PID, When the evaporative system is tested the display will change from OFF to ON. And when the test is complete the display will change back to OFF.
9. When the monitor changes back to OFF wait a few seconds the press the TRIGGER to save the recorded information.




10. Select VIEW RECORDING then press the TRIGGER.




11. Select both PID's by highlighting and pressing the TRIGGER.




12. Press the number key under GRAPH.

NOTE:
- It will be necessary to press Number 8 key to advance the graph to the point were the CDCV turned on.