With Manufacturer's Scan Tool

OUTLINE





- The ABS control module contains an on-board diagnostic and memory functions to detect and indicate present and past failures.
- Read and note the diagnostic indications by using the Special Service Tool (SST), and take action according to the Diagnostic Trouble Code Table.
- The ABS CM has a nonvolatile memory. Diagnostic trouble codes are not erased if the battery is disconnected. The memory should be cleared when servicing is finished

USING SST (NGS TESTER)
1. Connect the SST (NGS) to the data link connector and battery.





2. Set the SST (Super MECS Adapter) to ABS.





3. Select "VEHICLE & ENGINE SELECTION" on the SST (Control Unit) display, and then select the vehicle model, engine type, and model year.
4. Select "DIAGNOSTIC DATA LINK" on the SST (Control Unit) display.





5. Select "ANTI LOCK BRAKE MODULE" on the SST (Control Unit) display.





6. Select "DIAGNOSTIC TEST MODE" on the SST (Control Unit) display.
(1) If a trouble code is displayed, refer to the Diagnostic trouble code table and inspect the appropriate system area.
(2) If "No codes received" is displayed, the system areas shown in the Diagnostic trouble code table are okay. Inspect another system area.