Transmission Position Sensor/Switch: Testing and Inspection

TRANSAXLE RANGE SWITCH INSPECTION (GF4A-EL)
Inspection of Operation
1. Verify that the starter operates only with the ignition switch at the START position and the selector lever in P/N position.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch in the ON position.
3. Check the transaxle range switch, if not as specified.

Inspection of Continuity
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Disconnect the transaxle range switch connector.








4. Check for continuity at the transaxle range switch.
5. If not as specified, replace or adjust the transaxle range switch.
6. Connect the transaxle range switch connector.
7. Install the air cleaner component.
8. Connect the negative battery cable.