Transmission Speed Sensor: Service and Repair

INPUT/TURBINE SPEED SENSOR REMOVAL / INSTALLATION (GF4A-EL)
1. Disconnect the negative battery cable.
2. Remove the air cleaner component, battery, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.

Tightening torque 5.4 - 7.8 Nm (55 - 80 kgf-cm, 47 - 69 inch lbs.)

7. Connect the input/turbine speed sensor connector.
8. Install the battery, battery carrier, and air cleaner component.
9. Connect the negative battery cable.