Rear

REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.

Stabilizer Bushing Installation Note
1. Apply rubber grease to the inside surface of the stabilizer bushing.





2. Align the bushing with the stopper on the stabilizer.

STABILIZER CONTROL LINK INSPECTION
1. Inspect for bending and damage.





2. Measure the ball joint starting torque.
(1) Shake the ball joint stud from side to side 10 times.
(2) Rotate the ball joint stud 10 times
(3) Measure the starting torque by using an Allen socket and a torque wrench.

Starting torque: 0.1 - 1.9 Nm (0.9 - 17 inch lbs.).

3. If not within the specification, replace the stabilizer control link.