3. 2-3 Accumulator
2-3 ACCUMULATORDisassembly/Inspection/Assembly
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly, referring to ASSEMBLY PROCEDURE.
Inspection
2-3 Accumulator Spring
1. Measure the spring free length.
Specification
2. If not as specified, replace the spring.
Orifice Check Valve Spring
1. Measure the spring free length.
Specification
2. If not as specified, replace the spring.
Assembly Procedure
1. Apply ATF to the large and small seal rings and install them onto the accumulator piston.
Seal ring inner diameter
Large seal ring: 23.6 mm (0.929 inch)
Small seal ring: 14.6 mm (0.575 inch)
2. Install the 2-3 accumulator piston.
3. Install the spring to the piston.
4. Apply ATF to a new O-ring and install it onto the stopper plug.
O-ring inner diameter: 26.8 mm (1.06 inch)
5. Install the stopper plug into the accumulator body by applying even pressure to the perimeter of the stopper plug and accumulator piston.
6. Install the snap ring while holding in the stopper plug.