Radio, Stereo, and Compact Disc: Service and Repair

REMOVAL
1. Disconnect the negative battery cable.




2. Remove the hole covers by inserting a small, tape- wrapped, flathead screwdriver into the slot and carefully pry them off without scratching the front console. Pry up and pull off the hole covers carefully to prevent the posts from breaking off.
3. With the beveled parts of the SST facing inward, insert them into the audio unit.




4. Pull the SST outward and rearward to slide out the audio unit.
5. Disconnect the audio unit connector and antenna jack to remove the audio unit.

INSTALLATION

CAUTION:
^ Make certain that the wiring harness and antenna feeder are not caught between the audio unit and front console. If the harness or the antenna feeder is caught between the audio unit and front console, it may become the cause of trouble or malfunctions.
^ To install the audio unit, be sure to push service hole cover areas on both sides of the audio unit. If the switches are pressed instead, it may become the cause of trouble or malfunctions.

1. Connect the audio unit connector and antenna jack.




2. Insert the audio unit until each clip clicks.
3. Install the hole covers.
4. Connect the negative battery cable.