Base

REMOVAL
1. Wind each end of a wire around a bar.
2. Saw through the sealant, using a long sawing action to spread the work over the whole length of SST (piano wire) to prevent it from breaking.

INSTALLATION
1. Cut away all of the original sealant by using a razor knife.
2. Clean and degrease the glass.
3. Apply primer onto the bonding area of the glass and the base by using a brush. Use only glass primer on the glass and body primer on the base. keep the bonding area free of dirt and grease, and do not touch the surface. Allow the primer to dry for approximately 30 minutes.











4. Apply a 3 mm {0.12 in} bead of sealant to the base.
5. Center the base in the ceramic coating and press it onto the glass. Use white gasoline to remove any excess sealant.