Crankshaft Position Sensor: Testing and Inspection

CRANKSHAFT POSITION SENSOR TEST

1. Disconnect the crankshaft position sensor connector.




2. Measure the resistance between terminals A and B by using an ohmmeter.

Specification: 500 - 600 K ohms 20°C (68°F)

3. If not as specified, replace the crankshaft position sensor.




4. Measure the air gap between the crankshaft pulley projection and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5 - 1.5 mm (0.020 - 0.059 in)

5. If not as specified, adjust the air gap.