Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE SWITCH ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner component, and battery carrier.
3. Remove the nut and clip, then disconnect the selector cable.
4. Rotate the manual shaft to the N position.
5. Disconnect the transaxle range switch connector.
6. Hand-tighten the transaxle range switch mounting bolts.
7. Connect an ohmmeter between terminals A and H.




8. Adjust the switch to the point where there is continuity between the terminals.




9. Tighten the transaxle range switch mounting bolts.

Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 70 - 95 inch lbs.)

10. Verify that the selector lever range position and transaxle range switch are aligned.
11. Connect the transaxle range switch connector.
12. Connect the selector cable and install the nut and a new clip.


13. Install the battery carrier, air cleaner component, and battery.