Transaxle Assembly Removal and Installation
MANUAL TRANSAXLE REMOVAL/INSTALLATIONPart 1 Of 2:
Part 2 Of 2:
1. Drain the transaxle oil.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Add the specified amount and type of transaxle oil.
Engine Mounting Member Removal Note
1. Suspend the engine by using the SST
2. Remove the engine mounting member.
Manual Transaxle Removal Note
1. Loosen the SST (engine support) and lean the engine toward the transaxle.
2. Support the transaxle on a jack.
3. Remove the transaxle bolts.
4. Remove the transaxle being careful to not let it fall from the jack.
5. Remove the transaxle mounting bolts.
6. Remove the transaxle.
Manual Transaxle Installation Note
1. Set the transaxle on a jack and carefully lift into place.
2. Install the transaxle mounting bolts.
3. Hand-tighten the No.4 engine mount bolts and nuts.
No.2 Engine Mount Installation Note
- Hand-tighten the No.2 engine mount rubber nut.
No.1 Engine Mount Installation Note
CAUTION: Misaligning the bolts will cause damage to the bolt holes.
1. Use the SST (engine support) to make sure the transaxle bolt holes and No.1 engine mount meet evenly.
2. After the 3 bolts are set in the holes, tighten the bolts to the specified torque.
Tightening torque 67 - 93 Nm (6.8 - 9.5 kgf-m, 50 - 68 ft. lbs.)
Engine Mounting Member Installation Note
NOTE:
- Verify that the engine mount rubbers are installed as shown.
- Put the No.1 engine mount stud bolts in the installation holes when installing the engine mounting member.
1. Install the bolts and nuts as shown.
Tightening torque
A: 67 - 89 Nm (6.8 - 9.1 kgf-m, 50 - 65 ft. lbs.)
B: 38 - 51 Nm (3.8 - 5.3 kgf-m, 28 - 38 ft. lbs.)
2. Tighten the No.2 engine mount rubber nut.
Tightening torque 67 - 93 Nm (6.8 - 9.5 kgf-m, 50 - 68 ft. lbs.)
3. Tighten the No.4 engine mount bolts and nuts.
Tightening torque 67 - 93 Nm (6.8 - 9.5 kgf-m, 50 - 68 ft. lbs.)
4. Remove the SST (engine support).