Clearing Trouble Codes

HOW TO ERASE DIAGNOSTIC TROUBLE CODES WITH SST/NGS SCAN TOOL (AFTER REPAIR PROCEDURE)




1. Clear the diagnostic trouble code memory by using the SST (NGS). (Refer to Instruction Manual.)
2. Remove the SST (NGS) from the data link connector-2.




3. Drive the vehicle at 50 km/h (31 mph), and depress the accelerator pedal fully to activate kickdown. Stop the vehicle gradually.
4. Connect the SST (NGS) to the data link connector-2 and battery.
5. Turn the ignition switch to ON.
6. Verify that no diagnostic trouble codes are displayed.
7. Remove the SST from the data link connector-2.