Transmission Speed Sensor: Testing and Inspection
INPUT/TURBINE SPEED SENSOR INSPECTION1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner component, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Measure the resistance between the terminals of the input/turbine speed sensor.
Resistance 200 - 400 ohms (ATF temperature: -40 - 160°C (-40 - 320°F))
5. If not correct, replace the input/turbine speed sensor.
6. Connect the input/turbine speed sensor connector.
7. Install the battery carrier, air cleaner component, and battery.
8. Connect the negative battery cable.