Camshaft Position Sensor: Service and Repair

1. Disconnect the negative battery cable.
2. Disconnect the camshaft position sensor connector.
3. Remove the camshaft position sensor installation bolt.
4. Remove the camshaft position sensor.
5. Make sure that the camshaft position sensor is free of any metallic sharings or particles. If metallic sharings or particles are found on the sensor, clean them off.
6. Install the camshaft position sensor in the reverse order of removal.

Tightening torque: 7.9-10.7 Nm (80-110 kg.cm, 69.5-95.4 in.lb)