Output Speed Sensor Inspection
OUTPUT SPEED SENSOR INSPECTION1. Disconnect the negative battery cable.
2. Disconnect the output speed sensor connector.
3. Remove the output speed sensor.
Note: Resistance value output speed sensor varies with temperature. Normal resistance value occurs when the temperature is 20°C (68°F) but it may be abnormal at high temperatures. Therefore, do not determine the resistance value only at 20°C (68°F).
4. Measure the resistance between the terminals of the output speed sensor.
Resistance 387 - 473 ohms (20°C (68°F))
5. If not correct, replace the output speed sensor.
6. Install the output speed sensor.
Tightening torque 5.0 - 6.8 Nm (50 - 70 kgf-cm, 44 - 60 inch lbs.)
7. Connect the output speed sensor connector.
8. Connect the negative battery cable.