Temperature Sensor (Gauge): Service and Repair

REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the water temperature sender unit connector.

FS/2.0L:

KL/2.5L:

3. Remove the water temperature sender unit.

INSTALLATION




1. Apply sealant from the third thread to the top thread.
2. Install the water temperature sender unit.

Tightening torque:
11.8 - 17.6 N.m {120 - 180 kgf.cm, 105 - 156 in.lbf}

3. Connect the water temperature sender unit connector.
4. Connect the negative battery cable.