Removal/Installation

1. Complete the "BEFORE REPAIR PROCEDURE".
2. Disconnect the negative battery cable.
3. Remove the fuel tank.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.




6. Complete the "AFTER REPAIR PROCEDURE".

Fuel Pipe Disassembly Note

CAUTION: The retainer must be replaced if removed from the fuel pipe without using the SST. Otherwise, effectiveness of the retainer will be reduced.

1. Inspect that the quick release connector joint area is free of foreign materials. Clean as necessary.




2. Set the SST as shown and push into the quick release connector to disconnect the plastic fuel hose.




3. Cover the disconnected quick release connector and fuel pipe to prevent them from being scratched or contaminated with foreign materials.

Fuel Pipe Assembly Note
1. Inspect that the inside of the fuel pipe and the quick release connector is free of foreign materials and damage. Clean as necessary, taking care not to damage the sealing surfaces.




2. Push the quick release connector into the fuel pipe until a click is head.
3. Pull the quick release connector by hand and verify that it is installed securely.