Shift Indicator - A/T: Adjustments
INDICATOR PANEL ADJUSTMENT1. Loosen the indicator panel screws.
2. Shift the selector lever to P position.
3. Align the alignment screws in the slider with the holes in the indicator panel. Install heavy-gauge wire to hold the slider
4. Tighten the indicator panel screws in the order shown in the figure.
Tightening torque
2.0 - 2.9 Nm (20 - 30 kgf.cm, 18 - 26 inch lbs.)
5. Remove the heavy gauge wire.
6. Verify that the selector lever properly aligns with the indicator in each range.