Overdrive Switch: Service and Repair

O/D OFF SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front console.
3. Remove the indicator panel installation screws.
4. Disconnect the connector and remove the O/D OFF switch terminals.
5. Remove the selector lever knob component.
6. Install a new selector lever knob component.
Tightening torque
2.0 - 2.9 Nm (20 - 30 kgf.cm, 18 - 26 inch lbs.)
7. Install the O/D OFF switch terminals and connect the connector.
8. Install the indicator panel installation screws.
9. Install the front console.
10. Connect the negative battery cable.