Removal/Installation

Page 1 Of 2:

Page 2 Of 2:

MANUAL TRANSAXLE REMOVAL/INSTALLATION
1. Remove the battery, battery cover, and battery tray.
2. Remove the fresh air duct and air cleaner component.
3. Remove the wheels and tires.
4. Remove the splash shields.
5. Drain the transaxle oil into a container.
6. Remove the starter for.
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Add the specified amount of the specified transaxle oil.
10. Warm Up the engine and transaxle, inspect for the oil leakage, and inspect the transaxle operation.

Engine Mount Member Removal Note

CAUTION: To prevent damage to the body, insert a rag into the gap between the fender and body, when installing the SST.

1. Support the engine by using the SST before removing the engine mount member.





2. Remove the engine mount member.

Transaxle Removal Note
1. Loosen the SST (49 G017 5AO) and lean the engine toward the transaxle.





2. Support the transaxle on a jack.
3. Remove the transaxle Mounting bolts.
4. Remove the transaxle.

TRANSAXLE INSTALLATION NOTE
1. Set the transaxle on a jack and lift into place.





2. Install the transaxle mounting bolts.

No.2 Engine Mount, Engine Mount Member Installation Note





1. Position the direction indicator on engine mount member bushings facing toward the front side, and install the bushings onto the engine mount member.
2. To install the engine mount member, put the No.2 engine mount stud bolts through the engine mount member installation holes.
3. Install the engine mount Member bolts A and nuts A.

Tightening torque A: 67 - 93 Nm (6.8 - 9.5 kgf-m, 50 - 68 ft. lbs.)

4. Loosely tighten the No.2 engine mount nuts B.
5. Remove the SST (49 G017 5AO).





6. Tighten the No.2 engine mount nuts B.

Tightening torque B: 75 - 104 Nm (7.6 - 10.7 kgf-m, 55 - 77 ft. lbs.)