Using the SST (104 Pin Breakout Box)

1. Disconnect the PCM connector.




2. Connect the SST (104 Pin Breakout Box) to the PCM as shown.
3. Tighten the connector bolt.

Tightening torque : 7.9 - 10.7 N.m {80 - 100 kgf.cm, 69.5 - 95.4 in.lbf}

4. Warm up the engine to normal operating temperature.

Specification Except For California Emissions Regulations Applicable Model:

Specification For California Emissions Regulations Applicable Model:

5. Measure the voltage at PCM terminal 35, 60, 61 and 87.

6. If not as specified, inspect the following.
- Intake-air system
- Fuel system
- On-board diagnostic system
- Related harnesses

7. If these Systems are okay, replace the heated oxygen sensor.