Transaxle Range Switch Inspection

TRANSAXLE RANGE SWITCH INSPECTION [GF4A-EL]

Note Input signal of the TR switch can be inspected with the NGS tester.

Inspection of Operation
1. Verify that the starter operates only with the ignition switch at the START position and the selector lever in P and N positions.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch in the ON position.
- If not as specified, inspect the transaxle range switch.

Inspection of Continuity
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct, and air cleaner component.
3. Disconnect the transaxle range switch connector.








4. Inspect continuity of the transaxle range switch.
- If not as specified, replace or adjust the transaxle range witch
5. Connect the transaxle range switch connector.
6. Install the air cleaner component, fresh-air duct, and resonance chamber.
7. Connect the negative battery cable.