With Drum Brakes
WHEEL HUB, HUB SPINDLE REMOVAL/INSTALLATION (DRUM BRAKE MODEL)Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
LOCKNUT REMOVAL NOTE
1. Raise the staked portion of the locknut by using a small cape chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.
ABS SENSOR ROTOR (WITH ABS) REMOVAL NOTE
Note: The sensor rotor does not need to be removed unless replacing it.
- Remove the sensor rotor by using a chisel.
ABS SENSOR ROTOR (WITH ABS) INSTALLATION NOTE
Note: The ABS sensor rotor can be installed in either direction.
1. Install a new rear ABS sensor rotor onto the wheel hub.
2. Using a steel plate and the SST, press the rotor until it is flush with the wheel hub.
LOCKNUT INSTALLATION NOTE
- Install a new locknut and stake it as shown.
Tightening torque 177 - 235 Nm (18.0 - 24.0 kgf-m, 131 - 173 ft. lbs.)