Drive Axles, Bearings and Joints: Service Precautions

WHEEL AND TIRE REMOVAL/INSTALLATION
- The removal and installation procedure for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 89 - 117 Nm (9.0 - 12.0 kgf-m, 66 - 86 ft. lbs.).

BRAKE LINE DISCONNECTION/CONNECTION

Caution: Brake fluid will damage painted surfaces. If brake fluid gets on a painted surface, wipe it off immediately.

- Tighten the brake pipe flare nut by using the Special Service Tool (SST) (49 0259 770B). Be sure to modify the brake pipe flare nut tightening torque to allow for use of a torque wrench-SST combination.
- If any brake line has been disconnected any time during the procedure, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.

SUSPENSION ARM REMOVAL/INSTALLATION
- Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.

Note: Unloaded ... Fuel tank full; engine coolant and engine oil at specified level; spare tire, jack, and tools in designated position.