NGS Tester Hook-Up Procedure

NOTE: Make sure the ignition switch is OFF.




1. Insert the vehicle interface module and latest program card into the hand-held NGS control unit.




2. Plug the NGS OBD-II adapter into the vehicle interface module and the large 16 pin connector into the vehicle DLC-2 located under the left side of the center console.




3. Plug the NGS tester power connector into the NGS OBD-II adapter power cable connector or cigarette lighter. Alternatively, enable to use a battery hook-up adapter.
4. Listen for a double beep. The NGS tester is now initialized. Begin the powertrain control system functional test.