Input/Turbine

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the bracket and front pipe.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Remove the O-ring from the input/turbine speed sensor.
6. Apply ATF to the new O-ring.
7. Install the O-ring to the input/turbine speed sensor.
8. Install the input/turbine speed sensor.
Tightening torque
5.8 - 8.8 Nm (59 - 90 kgf.cm, 52 - 78 inch lbs.)
9. Connect the input/turbine speed sensor connector.
10. Install the front pipe and bracket.
11. Connect the negative battery cable.