Removal and Installation

REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the air intake wire from the blower unit.
3. Disconnect the air mix wire and airflow mode wire from the heater unit.




4. Remove the hole covers by inserting a small, tape-wrapped, flathead screwdriver into the slot, then carefully prying them off without scratching the center panel. Pry up and pull off the hole covers carefully to prevent the posts from breaking off.
5. With the beveled parts of the SST (Removing Tool) facing inward, insert them into the climate control unit.




6. Pull the SST (Removing Tool) outward and rearward to slide out the climate control unit.

INSTALLATION




1. Pass each wire through the following routes, then connect them to each unit.
2. Connect the climate control unit connectors.




3. Insert the climate control unit until each clip clicks.
4. Install the hole covers carefully to prevent the posts from breaking off.
5. Adjust the climate control unit wire.
6. Connect the negative battery cable.