Radio, Stereo, and Compact Disc: Service and Repair

REMOVAL
1. Disconnect the negative battery cable.




2. Remove the service hole covers by inserting a small tape-wrapped flathead screwdriver into the slot and carefully pry them oft without scratching the center panel. Pry up and pull oft the service hole covers carefully to prevent the posts from breaking off.

NOTE: Two SST (Removing tool) sets are required when removing an audio unit that includes the CD changer controller.

3. With the beveled parts of the SST (Removing tool) facing inward, insert them into the audio unit.




4. Pull the SST (Removing tool) outward and rearward to slide out the audio unit.
5. Disconnect the audio unit connectors and antenna jacks.

INSTALLATION

CAUTION: Make certain that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the harness or the antenna feeder is caught between the unit and dashboard, it may become the cause of trouble or malfunctions.

1. Install the audio unit service hole covers.
2. Connect the audio unit connectors and antenna jacks.




3. Insert the audio unit until each clip clicks.
4. Connect the negative battery cable.