Removal/Installation

1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system.
3. Remove the under cover, glove compartment, and glove compartment cover.
4. Remove the stay.
5. Remove the passenger-side air bag module.

CAUTION: If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.




6. Remove in the order indicated in the table. Do not allow compressor oil to spill. Immediately plug all open fittings to keep moisture and dirt out of the system.
7. Install in the reverse order of removal.
8. Perform refrigerant system performance test.

Cooling Unit Installation Note
1. When installing a new cooling unit (evaporator), add ATMOS GU10 compressor oil into the refrigeration cycle.

Supplemental amount
50 ml (50 cc, 1.7 fl oz}