Engine Tightening Specifications

Torque Sequences




Cylinder Head Removal




Cylinder Head Installation




Camshaft Front Bearing Cap Removal

Note: Bolt No.5 in the figure fits only the right cylinder head.




Camshaft Bearing Cap Removal

Note:
The front camshaft bearing caps must be removed first, otherwise damage to the camshaft will occur.
Remove the thrust caps only after removing all camshaft caps. Otherwise, the thrust caps can be damaged.





Camshaft Bearing Thrust Cap Installation

Caution: Install the thrust caps (5 mark on RH, B mark on LH) first. Otherwise, camshaft can be broken or damaged.




Camshaft Bearing Cap Installation


Tightening Torques

Cylinder Head
1. Tighten to 23.1 - 25.9 Nm (2.35 - 2.65 kgf-m, 17.0 - 19.1 ft. lbs.)
2. Tighten to 85° - 95°
3. Retighten to 85° - 95°

Camshaft Bearing Cap
1. Tighten to 11.3 - 14.2 Nm (115 - 145 kgf-m, 100 - 125 in. lbs)
2. Retighten to 11.3 - 14.2 Nm (115 - 145 kgf-m, 100 - 125 in. lbs.)

Crankshaft Pulley
Tighten to 157 - 166 Nm (16 - 17 kgf-m, 116 - 122 ft. lbs.)

Drive Plate
Tighten to 61 - 67 Nm (6.2 - 6.8 kgf-m, 45 - 49 ft. lbs.)

Oil Pump
Tighten to 19 - 25 Nm (1.8 - 2.6 kgf-m, 14 - 18 ft. lbs.)




Water Pump

Reuse/Replace




Cylinder Head Bolt
Length 131.2 - 131.8 mm (5.166 - 5.188 inch)
Maximum Length 132.5 mm (5.217 inch)