14. Control Valve Body (Disassembly)

CONTROL VALVE BODY (DISASSEMBLY)
Preparation





SST

Disassembly

CAUTION: Denting or scratching these components will reduce the ability of the transaxle to shift properly. When handling these components or the valve body that contains them, be careful not to drop or hit them.








1. Disassemble in the order shown in the figure, referring to Disassembly Procedure.
2. Neatly arrange the removed parts to avoid confusing the similar parts.

WARNING: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.

3. Clean the removed parts with cleaning solvent, and dry them with compressed air. Clean out all holes and passages with compressed air.

Disassembly Procedure





1. Remove the transaxle fluid temperature sensor by using the SST
2. Remove the pressure control, 3-2 timing, shift solenoid A, and torque converter clutch control solenoid valve.





3. Remove the O-rings from the solenoid valve.





4. Remove the bolts indicated by the arrows, then remove the front control valve body, premain separator plate, and gasket.
5. Remove the front/premain gaskets and separator plate from the front control valve body.
6. Remove the rubber ball from the front control valve body.
7. Remove the rubber ball from the premain control valve body.





8. Remove the bolts, premain control valve body, main separator plate, and gaskets.
9. Remove the premain/main gaskets and separator from the premain control valve body.
10. Remove the jet orifice and nut from the main separator plate.
11. Remove the rubber balls and oil strainer from the premain control valve body.
12. Remove the rubber balls and oil strainer from the main control valve body.





13. Turn the assembly over and remove the oil pipe, oil baffle, shift solenoid B, and shift solenoid C.





14. Remove the bolts shown in the figure and remove the rear separator plate and gaskets.
15. Remove the main/rear gaskets and separator from the rear control valve body.
16. Remove the rubber balls and oil strainers from the rear control valve body.
17. Remove the rubber balls and oil strainers from the main control valve body.