2. Torque Converter
TORQUE CONVERTERThe torque converter is welded together and cannot be disassembled.
Inspection
1. Check the outer part of the converter for damage or cracks, and replace if necessary.
2. Check for rust on the pilot hub of the converter or on the boss. If there is any, remove it completely.
3. Measure the bushing of the converter boss. Replace the, converter assembly if the bushing is excessively worn.
Bushing inner diameter
Standard: 53.000 mm (2.0866 inch)
Maximum: 53.045 mm (2.0884 inch)
Washing Inside Of Converter
1. Drain any ATF remaining in the converter.
2. Pour in ATF (approximately 0.5 L (0.5 US qt, 0.4 Imp qt)).
3. Shake the converter to clean the inside. Pour out the ATE
4. Pour in ATF again.
5. Shake the converter to clean the inside. Pour out the ATF.