Diagnostic Support Procedure

DIAGNOSTIC SUPPORT PROCEDURE [GF4A-EL]





1. Connect SSTs (NGS tester) to the DLC-2.
2. Turn the ignition switch to ON (engine OFF).
3. Select the DIAGNOSTIC SUPPORT PROCEDURE function on the SSTs (NGS tester) display.





4. Move the cursor to ALL TEST or SINGLE TEST. Press the trigger key.

Note ALL TEST inspects each item according to an established programmed order. With SINGLE TEST, enables to select and inspect any test item in any order, one at a time.

5. Follow the instructions displayed on the SSTs (NGS tester) and press the trigger key.





Note
- To skip a test item, press OMIT.
- Before performing the test, the basic condition on the test vehicle must be setup in order to get exact data. Press BASIC to view the basic condition instruction screen.
- If the screen shows PASSED, the system is operating correctly.
- If the screen shows FAULTY, the system is operating incorrectly.





Diagnostic support table