Diagnostic Support Procedure

NOTE: This is a specific function.

1. Perform the NGS Tester Hook-up Procedure.
2. Perform Steps 1 through 16 below.




1. Perform the necessary vehicle preparation and visual inspection.
2. Hook the NGS Tester up to the vehicle.




3. Move the cursor to VEHICLE & ENGINE SELECTION.
4. Press the TRIGGER key to enter this selection.




5. Move the cursor to SELECT NEW VEHICLE YEAR & MODEL.
6. Press the TRIGGER key to enter this selection.
7. Move the cursor to 2001-VIN#10:Z.
8. Press the TRIGGER key to enter this selection.
9. Move the cursor to the appropriate model.
10. Press the TRIGGER key to chose the model.

NOTE:
- Make sure the selected vehicle is correct.
- A vehicle selection screen showing the selected vehicle will be displayed.

11. Move the cursor to the vehicle selected.
12. Press the TRIGGER key.




13. Move the cursor to DIAGNOSTIC DATA LINK on the main menu screen.
14. Press the TRIGGER key to enter into menu system diagnostics.




15. Move the cursor to PCM - POWERTRAIN CONTROL MODULE.
16. Press the TRIGGER key to enter this selection.




3. Move the cursor to DIAGNOSTIC SUPPORT PROCEDURE.
4. Press the TRIGGER key to enter this selection.
5. Move the cursor to ALL TEST or SINGLE TEST.




6. Press the TRIGGER key.

NOTE: ALL TEST inspects each item according to an established programmed order. With SINGLE TEST, enable to select and inspect any test item in any order, one at a time.




7. Follow the instructions displayed on the NGS tester and press the TRIGGER key.

NOTE:
- To skip a test item, press OMIT.
- Before performing the test, the basic condition on the test vehicle must be set up in order to get exact data. Press BASIC to view the basic condition instruction screen.
- If the screen shows PASSED, the system operates correctly.
- If the screen shows FAULTY, the system operates incorrectly.