Simulation Test Procedure

NOTE: This is a specific function.

Idling test

1. Perform the NGS Tester Hook-up Procedure.
2. Perform Steps 1 through 16 below.




1. Perform the necessary vehicle preparation and visual inspection.
2. Hook the NGS Tester up to the vehicle.




3. Move the cursor to VEHICLE & ENGINE SELECTION.
4. Press the TRIGGER key to enter this selection.




5. Move the cursor to SELECT NEW VEHICLE YEAR & MODEL.
6. Press the TRIGGER key to enter this selection.
7. Move the cursor to 2001-VIN#10:Z.
8. Press the TRIGGER key to enter this selection.
9. Move the cursor to the appropriate model.
10. Press the TRIGGER key to chose the model.

NOTE:
- Make sure the selected vehicle is correct.
- A vehicle selection screen showing the selected vehicle will be displayed.

11. Move the cursor to the vehicle selected.
12. Press the TRIGGER key.




13. Move the cursor to DIAGNOSTIC DATA LINK on the main menu screen.
14. Press the TRIGGER key to enter into menu system diagnostics.




15. Move the cursor to PCM - POWERTRAIN CONTROL MODULE.
16. Press the TRIGGER key to enter this selection.

3. Start the engine and run it at idle.




4. Move the cursor to SIMULATION TEST.
5. Press the TRIGGER key to enter this selection.




6. Move the cursor to IDLING TEST.
7. Press the TRIGGER key to enter this selection.




8. The screen will display PIDs. Select the appropriate PID for testing, then press the TRIGGER key.

NOTE: Only one PID can be selected at a time.




9. Press START.

NOTE:
- If the screen displays "TEST CONDITION NOT CORRECT", check the following three signal conditions and determine whether or not they are normal:
- Idle SW: ON (Equipped vehicles)
- TR SW:P or N
- RPM: above 550

10. Press the TRIGGER key.




11. The simulation is performed for 3 s, and a "SIMULATION ACTIVATED PLEASE WAIT" message is displayed during those 3 s.
12. To perform the simulation again, press the TRIGGER key. To exit the idling test, press the cancel key.

Ignition on test

1. Perform Steps 1 through 16 below.




1. Perform the necessary vehicle preparation and visual inspection.
2. Hook the NGS Tester up to the vehicle.




3. Move the cursor to VEHICLE & ENGINE SELECTION.
4. Press the TRIGGER key to enter this selection.




5. Move the cursor to SELECT NEW VEHICLE YEAR & MODEL.
6. Press the TRIGGER key to enter this selection.
7. Move the cursor to 2001-VIN#10:Z.
8. Press the TRIGGER key to enter this selection.
9. Move the cursor to the appropriate model.
10. Press the TRIGGER key to chose the model.

NOTE:
- Make sure the selected vehicle is correct.
- A vehicle selection screen showing the selected vehicle will be displayed.

11. Move the cursor to the vehicle selected.
12. Press the TRIGGER key.




13. Move the cursor to DIAGNOSTIC DATA LINK on the main menu screen.
14. Press the TRIGGER key to enter into menu system diagnostics.




15. Move the cursor to PCM - POWERTRAIN CONTROL MODULE.
16. Press the TRIGGER key to enter this selection.

2. Turn the ignition key to ON (Engine OFF).




3. Move the cursor to SIMULATION TEST.
4. Press the TRIGGER key to enter this selection.




5. Move the cursor to IGNITION TEST.
6. Press the TRIGGER key to enter this selection.




7. The screen will display a list of PIDs. Select the appropriate PID for testing, then press the TRIGGER key.




8. Press START.
9. Press the TRIGGER key.




10. The simulation is performed for 3 s, and a "SIMULATION ACTIVATED PLEASE WAIT" message is displayed during those 3 seconds.




11. To perform the simulation again, press the TRIGGER key. To exit the ignition on test, press the cancel key.