Cylinder Head
| Cylinder Head | Sequences | Removal |
| Installation | ||
| (First Pass) Tighten To | 23.1-25.9 | |
| (Second Pass) Retighten | 85-95 Degress | |
| (Third Pass) Retighten Again | 85-95 Degress | |
| Front Camshaft Bearing Caps | Sequence | Removal Bolt No.5 in the figure fits only the right cylinder head. |
| Camshaft Bearing Caps | Sequences | Removal Remove the thrust caps only after removing all camshaft caps. Otherwise, the thrust caps can be damaged. Remove the camshaft cap bolts and camshaft caps. The front camshaft bearing caps must be removed first, otherwise damage to the camshaft may occur. |
| Installation Install the thrust caps (RH: 4, 8 marks, LH: A, E marks) first. Otherwise, the camshaft can be broken or damaged. | ||
| Camshaft Bearing Thrust Caps | Sequence | Installation |
| Camshaft Bearing Caps (all) | (First Pass) Tighten To | 11.3-14.2 |
| (Second Pass) Retighten To | 11.3-14.2 | |
| Camshaft Pulley | Sequence | Installation |
| Tighten To | 123-140 | |
| Cylinder Head Bolt Length | Standard | 133.7 - 134.3 mm |
| Maximum | 135.0 mm |