Output Gear

OUTPUT GEAR
Preparation





SST

Disassembly/Assembly





1. Disassemble in the order shown in the figure, referring to Disassembly Note.
2. Assemble in the reverse order of disassembly, referring to Assembly Procedure.

Disassembly Note
Bearing





1. Install the SST to the output gear as shown in the figure.
2. Remove the bearing from the output gear by using a press.

Assembly Procedure





1. Press in the bearing to the output gear by using a suitable plate.





2. Apply ATF to the new seal ring and install it to the output gear.

Seal ring inner diameter: 30.78 mm (1.212 inch)