Side Protector

SIDE PROTECTOR REMOVAL




1. Pry the side protector end 20 - 30 mm (0.8 - 1.1 in) using a flathead screwdriver or a razor.

WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

2. Pull the side protector toward you, then remove it.

NOTE: The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove, soften the double-sided adhesive tape using a hot air blower.

SIDE PROTECTOR INSTALLATION

1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body.




3. Attach double-sided adhesive tape to the side a protector as shown (if it will be reused).

Clearance
a: 5.0 mm {0.20 in}
b: 15.0 mm {0.590 in}
c: 1.0-3.0 mm {0.04-0.11 in}
d: 2.5 mm {0.10 in}
e: 20.0 mm {0.787 in}
f: 7.0 mm {0.28 in}




4. Peel off the backing from the double-sided adhesive tape and attach the side protector onto the body as shown.

Clearance
a: 1.0 - 4.0 mm {0.04 - 0.15 in}
b: 3.0 - 5.0 mm {0.12 - 0.23 in}
c: -1.5 - 1.5 mm {-0.06 - 0.05 in}